How much dirt is in a hole riddle?

How much dirt is there in a hole that measures two feet by three feet by four feet? None. A hole doesn’t have any dirt. None.

How much dirt is in a round hole that is 7 feet deep with a diameter of 4.5 feet?

How much dirt is in a round hole that is 7 feet deep with a diameter of 4.5 feet? None at all. The hole is made by digging dirt out, so… the hole is empty.

How much dirt is there in a hole that is 4 feet by 5 feet by 6 feet?

It would be 80 cubic ft . Dirt volume is usually given in yards . And actually it refers to cubic yards .

How much dirt does it take to fill a hole?

Calculate the volume of dirt needed to fill in the hole using pi (3.142) times the square of the radius times the depth. For this example, you would multiply 3.142 by the square of 30 by 30 to obtain the volume. This yields 3.142 times 900 inches times 30 inches, or 84,834 cubic inches.

How many times can you subtract 5 25?

You can subtract 5 from 25 infinite times. Because there is no limit where to stop.

How many cubic feet of dirt are there in a hole that is 3 deep and 3 wide and 3 long?

If this is a typical math question, then to dig a hole in the ground that is 3′ by 3′ by 3′, you would have to remove 27 cubic feet of dirt.

How much dirt is in a 4 foot deep?

Q: “How much dirt may be removed from a hole that is 4 feet deep, 2 feet wide and 5 feet long?” None. Zero.

How do you calculate backfill?

How to Calculate Backfill

Calculate the volume of the space to be filled.
Calculate the cubic yardage of the same trench.
Next you might need to fill a round hole that is 10 feet in diameter and 5 feet deep.
Estimate the number of truckloads that will be required to fill these two holes with backfill.

How deep is a 6 foot hole explanation?

If you dig the hole 6 feet wide, then the hole can be 1,2,3,4 feet deep but if you dig the hole 6 feet deep, it’s gonna be 6 foot deep.

How many cubic yards of dirt to fill a hole?

It will require 1.82 cubic yards of dirt to fill in the hole. If your measurements are in feet, you can convert cubic feet to cubic yards by dividing cubic feet by 27 cubic yards.

Is there really any dirt in a hole?

A hole doesn’t have any dirt. What is the secret to this? 6 Comments on “How Much Dirt?” There is no dirt. Its a HOLE! Although the comment above is remarkably astute, the grammatical errors present in the comment are intensely embarrassing. Also, there is always dirt in a hole. Haven’t you studied dirt???

How to calculate the density of fill dirt?

Type in inches and feet of your project and calculate the estimated amount of Soil & Dirt in cubic yards, cubic feet and Tons, that your need for your project. The Density of Fill Dirt: 2,410 lb/yd³ or 1.21 t/yd³ or 0.8 yd³/t

How big is a 40 pound bag of soil?

In the US, a 40-pound bag measures between 0.5 and 0.75 cubic feet. The Soil Calculator bag estimator is based on 0.75 cubic feet per bag. If you want to do the calculations by hand, then skip Step 4 above, and do the following: 1. Make sure all measurements are in the same units (usually feet or meters).

How big is a 6 foot deep hole?

A 6 foot hole is roughly 1.83 metres deep in metric units. This is a very deep hole that would require earthwork support and means of access in and out of the hole. To give you an idea of how deep this hole is, the average height of human beings around the world ranges from 5 foot (152cm) to (6.10 foot (185.6cm).

Is there a calculator for fill dirt?

Our fill calculator can help you figure out how much fill dirt you will need for your construction project. This cubic yard calculator works with top soil, mulch, gravel, dirt fill, clean fill, fill dirt.

How long does it take to dig a 4 foot hole?

Manual excavation standard output rate for excavating in heavy soil for trenches 4 to 6 feet deep: 0.46 cy per hour. Therefore, (4 x 1)/0.46 = 8.70 hours. It takes 8.70 hours to dig 4 cubic yards of earth in heavy soil (clay, shale, caliche, etc).

What kind of dirt do you use to fill a hole?

Fill dirt typically consists of subsoil, which is found about twelve inches below the topsoil. Subsoil itself consists of partially broken down clay, sand, silt, and stones, and any other materials found in the source ground. Fill dirt is stony, heavy, and inorganic.

How much dirt is there in a hole that is 3 feet deep & 6 inches in diameter?

The volume of the hole is : V = d x l x w = 3 x 6 x 4 = 72 cubic feet. The weight of the dirt depends, therefore, on its average density.

How many inches of topsoil does it take to grow grass?

The Root of the Matter It can also also make the lawn more susceptible to drought stress or require more frequent watering. Grass roots grow between 4 and 6 inches long, so a layer of topsoil that’s 6 inches deep provides enough room for the roots to grow.

How thick should topsoil be?

To spread over a garden bed, you’ll want enough to give you at least a 2-inch layer. To install a new lawn, plan to spread a layer of 3-6 inches of topsoil before sowing seed or laying sod, depending on the quality of your existing soil.

How many times can 6 Subtract from 30?

FIVE TIMES: If we subtract 6 from 30 it would result 24, then subtracting 6 from 24 results 18. If we keep subtracting in the same sequence, the subtraction would happen 5 times.

How many times can you take 3 25?

It is once, because after you subtract 3 from 25 once, you are left with 22. Thus, you cannot subtract 3 again from 25. 8.33 times, because 25 divided by 3 is 8.33. After you subtract 3, 8.33 times from 25, then there is nothing left to subtract from.