How do I connect my void wireless headset?

Pair the VOID PRO RGB Headset and Wireless Receiver Dongle

Plug the wireless receiver dongle into the computer.
With the dongle plugged in, locate the tiny hole near the dongle’s LED.
Using a paper clip, press into the hole until the dongle’s LED begins to blink rapidly.
Hold down the Power button on the side of the headset until the dongle’s LED turns solid.

How do I reset my void Elite Wireless?

How to: Reset a Void Pro RGB Headset

Make sure your headset is currently unplugged.
Make sure your headset is powered on.
Hold the Mute button on the headset down for about 15 seconds.
Hold down the power button until the headset turns on.
Test your headset and see if the issue is resolved.

Can you replace Corsair void pro dongle?

No but you can purchase replacement Void Pro Wireless dongles from the Corsair website. Make sure your headset is the Void PRO Wireless and not the first generation Void Wireless as they will not work with the first generation Void headsets.

Can I use Corsair void elite wireless while charging?

Yes absolutely can be used while charging.

Can I use Corsair void pro while charging?

Above you can see the dongle (wireless USB adapter) and 1.5m USB charging cable. If it should happen that the battery is empty during gaming, then just plug it into the USB port and you can use it while charging. …

How long does it take to fully charge Corsair virtuoso?

Wireless Corsair headsets charge via the included micro-USB cable, and normally take an hour or two to charge completely (depending upon the output of the power source). If you’re using a USB port on a computer to charge, make sure the port is powered.

How long does it take to charge Corsair harpoon wireless?

about two hours

How do I add Bluetooth to my Corsair Mouse?

In order to get the mouse into pairing mode you need to turn it off and then hold down the DPI Cycle Button and while holding it down, put it into bluetooth mode. The LED indicator should continue to flash, showing that the mouse is in bluetooth pairing mode.

How do I connect a wireless mouse dongle?

How to re-pair the USB RF dongle to the mouse

Power on the mouse and make sure it has sufficient level of battery power and set it to RF mode . Make sure the mouse is physically close to the dongle.
Please make sure the RF dongle is unpluged from the computer USB port.
Insert the dongle or new dongle to the computer’s USB port.

How do you test an ironclaw battery?

You have to rely on the little LED indicators on the left side of the mouse, and they only show up when you turn the mouse on (meaning that to check battery life, you have to turn the mouse off and then on again).

How do I reset my Corsair harpoon wireless?

With the mouse unplugged, hold down the left and right mouse buttons. While holding down the mouse buttons, plug the mouse back into the computer. After around 5 seconds, release the buttons. You will see an LED flash if it resets successfully.

Can a wireless mouse go bad?

What Makes a Wireless Mouse Go Bad? It may sound obvious, but your batteries may have died, not the mouse. This “solution” may work temporarily, and if it does work, it’s a sure sign that you need to replace the batteries. It is highly unlikely that a wireless mouse of a reputable brand will just “die” on you.

Why did my wireless mouse suddenly stop working?

Resync your devices with the USB receiver. Sometimes the receiver gets out of sync with the wireless devices, causing them to stop working. Press that, and a light on the receiver should start flashing. Then press the Connect button on the keyboard and/or mouse and the flashing light on the USB receiver should stop.